Device List - Lowrance HDS Carbon Installation Manual

Data sources - manual source selection
Manual selection is generally only required where there is more
than one source for the same data, and the Auto configure
selected source is not the one desired. Pressing the menu key when
the desired source is highlighted provides additional options:
Configure device
Additional device options can be configured from both the Data
source menu or from the Device list. For further information, refer to
"Device list" on page 35.
Scope
The active data source under any given category, can be set to be
Global or Local.
When a source is set as Global, it will be used by all displays on the
network.
When a source is set as Local, it will only be used by the display that
selected it as the source.
Ú Note:
If changing a display from a Global source to a different
Local source, change the Scope setting to Local before changing
the selected source, otherwise all other displays will be
changed over to the new source.
Ú Note:
Local and Global data settings apply to the selected data
source only. It is not possible to discretely set whether a data
source is Global or Local if it is not the active source on the
display being operated.
Reset Global/Local
Selecting Reset Global runs an Auto data source selection, and
overrides all previous manual source selections made on all
networked devices.
Selecting Reset Local reverts all data source selections on the unit
being used to the Global source settings available from other
networked units.

Device list

The Device list shows the devices that provide data. This may
include a module inside the unit, or any external NMEA 2000 device.
Software Setup | HDS Carbon Installation Manual
35