Table of Contents
Advertisement
Operating the Grass Trimmer
Step 1 - Removing the blade protector
Remove the blade protector.
Step 2 - Starting the Engine
Choke will automatically
return to 'Run' position
when Throttle is pressed
Pull cord until motor runs
2a To start a cold engine
1) Lay the machine on a flat surface free of growth. resting it on the motor and on the protective
hood.
2) Set START/STOP switch (
) to START.
A
3) Gently press primer bulb (
) often enough that no more bubbles are visible (approx. 7 times).
B
4) Set choke lever (
) fully downwards (Full Choke).
C
Customer Helpline 0845 034 2279
8
www.gardenservicecentre.co.uk
A
B
D
C
Operating the Grass Trimmer
Step 2 - Starting the Engine (continued)
5) Use your left hand to hold the appliance firmly by the rear handle whilst facing the rear of the
trimmer.
6) Pull out the pull cord until you feel resistance. Then pull vigorously 3 to 4 times. When the
engine ticks over (the engine has ignited).
7) Set the choke lever to the mid-position (Half Choke).
8) Pull the start grip (
) again quickly and strongly until the motor runs.
D
9) After about 30 seconds of warming up and getting up to speed you can operate the machine.
2b To start a warm engine
1) Set the switch to (START).
2) Set the choke lever to (RUN).
Step 3 - Trimming
B
A
2e Running Throttle Position
Hold the trimmer with the right hand on the rear handle and the left hand on the front handle.
Press and hold the throttle lockout trigger (
NOTE! Keep a firm grip with both hands while in operation.
NOTE! The trimmer should be held in a comfortable position with the rear handle about hip
height.
NOTE! Always operate trimmer at full throttle.
WARNING! Never operate this unit on the operator's left side.
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
)and squeeze the throttle trigger (
) as required.
B
A
9
Hide quick links:
Advertisement
Table of Contents
