Step 4 - Extending Spool Line While Trimming; How To Replace The Spool/Spool Line; Step 1 - Removing The Spool; Step 2 - Replacing The Spool Line In The Spool - Qualcast CDB30 Assembly Manual

Operating the Grass Trimmer

Step 4 - Extending spool line while trimming

1) While the line spool is running at full speed, tap its underside briefly against the ground.
2) If the spool lines are still not sufficiently extended, tap the underside against the ground again.
3) If the line has already become too short, it will no longer be extended by pressing the
underside against the ground. You must pull it out from the line spool by hand.
4) Switch off the motor.
5) Lay the machine on the ground.
6) Push by hand on the underside of the line spool and pull both lines out until they are
somewhat longer than the edge of the protective bonnet. The lines are trimmed to the correct
length by the line trimming knife.
WARNING! Ensure there is mixed fuel in tank with the correct ratio of fuel to oil. Make sure all
guards and handles are properly and securely attached.

How to Replace the Spool/Spool Line

Step 1 - Removing the spool

SPOOL COVER
– Twist off and remove the cover of the spool. (Rotate clockwise to loosen)
– Remove the spool.
Do not lose the spring!
Customer Helpline 0845 034 2279
10
www.gardenservicecentre.co.uk
Dangerous
Direction of
cutting area
rotation
Best cutting
area
SPRING
SLOTS
EYELETS
STRING HEAD
SHAFT
How to Replace the Spool/Spool Line

Step 2 - Replacing the spool line in the spool

SPRING SPOOL
ARROWS ON
SPOOL
ANCHOR
HOLE
FIRST LINE
SLOT
– Completely remove the remains of the spool.
– Make a nick in the middle of the new line, and hook it into the slot in the spool.
– Wind on a spool line on each side of the spool in the direction of the arrow.
Step 3 - Replacing the spool line in the spool
– Press both lines into opposite slots (line length about 15 cm).
– Thread both lines into the openings of the spool casing.
– Carefully push the line spool with its spring into the spool casing. When doing so, pull the lines
out through the eyelets.
– Continue to hold the line spool tightly. One after the other give a tug on the lines so that they
run out of the openings freely.
– Press the line spool in, and turn it clockwise as far as the stop.
– Keep hold of the line spool and twist it slightly back. The line spool must remain firmly fixed in
the pushed in position.
– Screw the cover back onto the line spool and turn it tight by hand. Adjusting the lines to the
right length.
– Push on the underside of the line spool by hand and pull out both lines out until they are
somewhat longer than the edge of the protective bonnet. The lines are trimmed to the correct
length by the line trimming knife.
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
FIRST LINE
SLOT
SECOND LINE
ARROWS ON
SPOOL
11