QERIDOO Kidgoo1 User Manual
Q8000a-lv;q8000-s-lv;
q9000a-lv;q9000-s-lv
Hide thumbs
Also See for Kidgoo1:
- User manual (8 pages) ,
- User manual (44 pages) ,
- User manual (44 pages)
Table of Contents
Related Manuals for QERIDOO Kidgoo1
Summary of Contents for QERIDOO Kidgoo1
- Page 1 User manual Kidgoo1 – Q8000A-LV / Kidgoo1 Sport Q8000-S-LV Kidgoo2 – Q9000A-LV / Kidgoo2 Sport Q9000-S-LV This product fulfils all safety requirements of the European standard for bicycles and bicycle trailers (DIN EN 15918).
-
Page 2: Table Of Contents
Relocate brake cable Maintenance intervals Inserting the wheels This documentation can be ordered from Qeridoo GmbH in other languages, or is available for Before every ride Tightening the backrest download on our website if already available. Monthly (or every 200 km) Visit us at: www.qeridoo.de... -
Page 3: Introduction
Requirements for the tow bar Kidgoo Kidgoo1 Kidgoo2 function. For Trailer mode, use a tow bar with coupler to connect the trailer to a suitable towing Permissible tow bar load range (on the coupler pocket) 3 –... -
Page 4: Safety Instructions
ƒ the back of the trailer for journeys in darkness or conditions of poor visibility. Qeridoo. Using other products relieves the manufacturer of liability. Before every journey, close the inner part of the 3-in-1 canopy so that the integrated insect ƒ... -
Page 5: Cycling With A Trailer
76 cm and the is 85 cm wide. Maintain a sufficient distance from ƒ Kidgoo1 Kidgoo2 obstacles and avoid routes that are too narrow. Always negotiate narrow points and bends slowly. Combined, the bicycle and trailer are at least 2.5 m long in total. Negotiate curves with wider ƒ... -
Page 6: Components And Control Elements
Product overview Product overview Components and control elements Components and control elements Side view Rear view Cabin (frame made from aluminium tubes Wheel guard for deflecting obstacles Push handle with safety function as Coupler pocket with cotter pin fastening with weatherproof fabric cover) roll-bar and retaining strap for securing the tow Tow bar for Trailer mode (in the standby... -
Page 7: Accessories
Product overview Product overview Accessories Rain cover Art. no.: JR-8-1 Kidgoo1 Using the accessories listed here, you can extend your and optimally adapt it to suit your Kidgoo Art. no.: R-100-2 needs and the age of your children: Kidgoo2 Coupler Folding garage Art. -
Page 8: Assembly
Also pay attention to the door width at the place of installation: The is 76 cm wide Q8000-S-LV Q9000-S-LV Kidgoo1 In the as-delivered state, wheel axle, disk brake and push handle are connected via the with the wheel guards fitted and the is 86 cm wide. -
Page 9: Fitting The Wheel Guard
Assembly Assembly Fitting the wheel guard Place the quick-release screws from the outside through the holes of the following parts to secure the The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars or connection: similar obstacles. -
Page 10: Inserting The Wheels
Assembly Assembly Inserting the wheels Open the cover of the storage space and check the tension of the 5 harnesses behind the backrest. Place the cabin on one side to allow the wheel to be inserted more easily. Pull the harnesses that are tensioned around the Insert one wheel into the wheel axle: upper crossbar so that a clearance of approx. -
Page 11: Adjusting The Buggy Wheel
Assembly Assembly Adjusting the buggy wheel In the as-delivered state, the supplied coupler is connected to the tow bar: Undo the cotter pin fastening and remove the coupler. Use the mode switch [A] and the release button [B] at Next, insert the cotter pin fastening back into the the front of the wheel suspension to set the required operating mode: coupler pocket of the tow bar. -
Page 12: Installing Optional Accessories
Pay attention to the following instructions: from Maxi Cosi and the Qeridoo baby seat 0+ (art. no. The labels R and L on the adapters must be located on the right and left exterior sides. -
Page 13: Utilisation
Assembly Utilisation Open the harness catch of the safety harness. Below you will find all the information for adapting the to the required modes and to Kidgoo allow you to use all the convenience functions. Place the baby seat into the adapter; the lock of the baby seat must engage audibly on both sides. -
Page 14: Setting The Disk Brake
Utilisation Utilisation Danger! Caution! Always check if the braking effect is sufficient. Adjust the brake immediately if you can Both disc brakes are adjusted optimally, if the brake linings have a distance of approx. push the when the parking brake is applied. 0.5 mm each to the brake disc when they are not being used. -
Page 15: Kidgoo Kidgoo
Utilisation Utilisation Adjusting the push handle Danger! Check the brake cable, the ends of the brake rope and the brake linings for damages Use the two light grey pushbuttons to alter the height of the push handle. These are identified before changing the brake settings. -
Page 16: Adjusting The Buggy Wheel
Utilisation Utilisation Adjusting the buggy wheel Attaching the hand strap You must make the following settings, depending on the mode. In Buggy and Walker mode, the hand strap secured to the push handle must be attached to your wrist during every journey. Ensure you can safely operate the disk brake brake lever * even when Removing the buggy wheel (Trailer mode) the hand strap is applied. -
Page 17: Embarking The Children
Utilisation Utilisation Undo the upper fastener of the two inner harnesses. Strapping in children Change round their pads and tongues: Push the pad and the tongue of the inner left – harness onto the right harness. Push the pad and the tongue of the inner right –... -
Page 18: Connecting The Trailer To A Bicycle
Reduce the baggage weight in the storage space. : Make sure that the loaded trailer weighs less than 50 kg. Kidgoo1 Using the climate functions : Make sure that the loaded trailer weighs less than 60 kg. -
Page 19: Adjusting The Suspension
Utilisation Utilisation Closing the weather canopy: Adjusting the suspension Open the top toggle fasteners and unroll the weather The leaf suspensions of the can be adjusted simply by moving the clamps. Using the scale Kidgoo canopy over the insect net. on the leaf suspension cover, you can adjust the suspension to the respective load. -
Page 20: Storage
The storage location should be dry, well ventilated and protected against direct sunlight. ƒ At higher storage temperatures, you should store the wheels separately from the cabin ƒ because the tyres’ rubber can cause odours. Use a Qeridoo folding garage if the must be kept outdoors, see “Accessories” on ƒ Kidgoo page 38 –... -
Page 21: Maintenance Intervals
Care and maintenance Care and maintenance Maintenance intervals Monthly (or every 200 km) Check the textile cover, all fasteners, the seats and the safety harnesses for cracks, wear and ƒ Caution! missing parts. Replace corroded steel and aluminium parts immediately. Inspect all frame tubes and all connecting pieces and fastening components for signs of wear ƒ... -
Page 22: Appendix
Width (external width from wheel to wheel) 76 cm 86 cm Under no circumstances shall Qeridoo be liable for material damage or injury attributable to Height (from ground to cabin roof) 92 cm 92 cm improper assembly, the intentional alteration of components or the non-observance of warning... -
Page 23: Spare Parts
Appendix Appendix Spare parts Pos. Article Article No. Article No. Kidgoo1 Kidgoo2 (valid from 2017) Horizontal bar foot space QT-517 QT-5999 12R-552 12R-552 Frame connecting plate Complete tow bar with coupler DIE-80-1-17 DIE-900-1-17 8.5" buggy wheel, complete (with wheel suspension and quick-... - Page 24 DAC-556-Q8 Wheel axle complete with disc Plastic holder front for roof brakes frame rods ACS-08L-S PLK-Q8 Art. no.: Art. no.: Kidgoo1 Art. no.: ACS-09L-S Kidgoo2 Brake cable incl. brake lever Connecting piece for rear rod Art. no.: BRV-888 Art. no.:...
- Page 25 Kidgoo Qeridoo GmbH Reutherstraße 3, 53773 Hennef (Sieg) Germany www.qeridoo.de info@qeridoo.de...