Creating A Local User; Setting Attributes Of Local User - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches
Table 3-2 Configuring relevant attributes of ISP domain
Specify the adopted RADIUS scheme
Restore the adopted RADIUS scheme to
the default RADIUS scheme
Specify the ISP domain state to be used
Set a limit to the amount of supplicants
Restore the limit to the default setting
Set the idle
By default, after an ISP domain is created, the used RADIUS scheme is the default one
named "system" (for relevant parameter configuration, refer to the Configuring RADIUS
section of this chapter).,the state of domain is active , there is no limit to the amount of
supplicants ,and the idle-cut function is disabled.

3.2.3 Creating a Local User

A local user is a group of users set on NAS. The username is the unique identifier of a
user. A supplicant requesting network service may use local authentication only if its
corresponding local user has been added onto NAS.
Perform the following configurations in system view
Table 3-3 Creating/Deleting a local user and relevant properties
Add local users
Delete all the local users
Delete a local user by specifying its type
(S3526, S3526 FM and S3526 FS
switches don't support ssh parameter.)
By default, there is no local user in the system.

3.2.4 Setting Attributes of Local User

The attributes of a local user include its password display mode, state, service type and
some other settings.
Operation
Operation
Huawei Technologies Proprietary
3-5
Chapter 3 AAA and RADIUS Protocol Configuration
Command
radius-scheme radius-scheme-name
undo radius-scheme
state { active | block }
access-limit { disable | enable
max-user-number }
undo access-limit
idle-cut { disable | enable minute
flow }
Command
local-user user-name
undo local-user all
undo local-user { user-name | all
[ service-type { lan-access | ftp |
telnet | ssh } ] }