Cleaning Reminder - AEG BCS551020M User Manual

10.3 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
2
Install the shelf supports in the opposite
sequence.
10.4 Catalysis
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Clean the inner glass of the oven door
with warm water and a soft cloth.
Remove all accessories.
The walls and the top of the cavity are
coated with catalytic enamel. It gathers
fat and dirt which burns off at high
temperatures without leaving a smell.
To support this self-cleaning process
heat the empty appliance regularly.
Spots or discolouration of
the catalytic surface have no
effect on its catalytic
properties.
1. Set the Catalysis function. Refer to
"Oven functions".
The display shows CATA and the
duration of the cleaning procedure (1
hour). You cannot change the duration,
but you can use the End function to
delay the start of the cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2. Push a button to stop the acoustic
signal.
3. Clean the bottom of the appliance
with a damp soft sponge.
To stop Catalysis before it finishes, turn
the knob for the oven functions to the off
position.

10.5 Cleaning reminder

As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Catalysis function.
• if you press
the same time.
10.6 Catalytic fan cover
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of
the catalytic surface have no
effect on catalytic
properties.
ENGLISH 29
and at