Settings - Electrolux GA55LICN User Manual

8 www.electrolux.com
5.1 Consumption values
Programme
1) The pressure and the temperature of the water, the variations of the mains supply, the op-
tions and the quantity of dishes can change the values.
5.2 Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com

6. SETTINGS

6.1 Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation or deactivation of the
rinse aid empty notification.
• The level of rinse aid according to the
required dosage.
• The activation or the deactivation of the
option AirDry.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme indicator
Water
1)
(l)
9.9
7 - 12
12.5 - 14.5
10 - 12
10
4
Energy
(kWh)
0.832
0.6 - 1.4
1.4 - 1.7
0.9 - 1.0
0.7
0.1
Write down the product number (PNC)
that is on the rating plate.
is on and the display shows the
programme duration.
When you activate the appliance, usually it
is in programme selection mode.
However, if this does not happen, you can
set the programme selection mode in the
following way:
Press and hold simultaneously Delay and
Start until the appliance is in programme
selection mode.
6.2 The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
Duration
(min)
225
50 - 160
175 - 190
70 - 80
30
14