Motorola MX101 Product Reference Manual page 154

8 - 8 MX101 PRODUCT REFERENCE GUIDE
Connect the cable to the micro USB port on the bottom of the scan module. Ensure the cable is clipped
7.
into the scan module plastic directly below the USB port.
Slide the CSS tower cover back into place. Ensure the cable service loop folds up into the blank space in
8.
the CSS tower cover, on the opposite side of the scan module. Snaps should click together. When the
tower cover is replaced, the module locks into the grommet compression ribs on the MP6000.
Replace MP6000 tower bezel. Snap down into place.
9.