Included; Installation And Removal Of Exhaust Hose - Sharp CV-P09FR Service Manual

CVP09FR

[3] INCLUDED

SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION
1. Screwdriver(medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Saw (In the event that the window panel needs to be cut down in size because thewindow is too narrow for direct installation.)

[4] INSTALLATION AND REMOVAL OF EXHAUST HOSE

Exhaust hose (1) Window exhaust adapter (1)
Suction disk (1)
Theexhaust h osemustbe installed orremoved in accordance w iththeusagemode.
Mode
COOL, FAN, VENTILATION Install
DEHUMIDIFICATION Remove
Installation of the exhaust hose
1 Attach the insect guard net to the ex-
haust adapter .
Pushthe insect guard net firmly to ensure
that four projectionson the exhaustadapter
fit into the four holes on it.
2 Attach the Exhaust adapter to the
exhaust hose.
Extend one end of the exhaust hose and
insert it into the Exhaustadapter,and turn
it (approx. three times) until it stops .
Make sure they are securely attached
afterwards.
3 Attach the exhaust hose adapter to
the unit.
Insert the two projections on the exhaus t
hoseadapterinto the two holeson the unit,
and firmly attach them to each other .
4 Lead the exhaust hose outdoors
Suction disk may be used to keep window
or door closed.
The exhausthoseshouldbe as shortas possiblefor operationalefficiency;
however, it must not be twisted or bent
Unacceptable
Removal of the exhaust hose
1 Remove the exhaust hose adapter from
the unit.
Lift up and remove the exhaust hose adapter
from the unit by pushing down on the two
projections.
Insect guard net (1)
Battery (2)
Remote control (1)
(AAA.R03)
Exhaust hose
Exhaust adapter
Extend
Exhaust hose
Suction disk
.
Acceptable
Acceptable
2 – 3
Hose clamp (1)
Manual (1)
Projection
Hole
Insent guard net
Projection
Hole
Projection