Advertisement
1
Rack Rear
Shipping
bracket
hooks
Securing the server in the rack with non-threaded
holes for shipping.
For servers installed in the rack with non-threaded
holes, install the shipping bracket 1 marked "Left"
to the rear of the left rail. Before installing, check
the non-threaded holes on the rack to see whether it
is square-shaped or circle-shaped. Afterwards, align
the shipping bracket to the corresponding hole on
the side of the rail marked "1U". After knowing
which hole to align with, insert the shipping
bracket hooks into the holes of the rail. Upon
insertion, a small gap will exist between the
shipping bracket and rail. Meanwhile, you will
notice the holes on the shipping bracket and rail are
not entirely aligned yet. For full alignment, press on
the part of the shipping bracket where the holes are
located and shift the shipping bracket to either the
square-shaped or circle-shaped icon. Finally, install
the screw 2 to secure the shipping bracket to the
rack. Refer to the illustration on the right for further
details.
Install the other shipping bracket to the rear of the
right rail.
14
Circle-shaped holes
A
B
Square-shaped holes
(For 1U server
circle-hole rack)
Securing the server in the rack with non-threaded
holes for shipping (continued).
(For 1U server
square-hole rack)
Shipping bracket
Advertisement
