Advertisement
For rack with square-shaped or circle-shaped holes
1
Rack Rear
Installing the rear end of the rails in a rack with
non-threaded holes.
Note: The non-threaded holes on the rack will
either be square-shaped or circle-shaped.
Choose one of the rails for installation. By facing
the front side of the racks, line up the pins on the
rear of the rail with either the square-shaped or
circle-shaped holes on the rear of the rack. Push the
rail so that the pins go into the holes and latches
into place.
8
Installing a 1U server into the rack
Square-shaped holes
Circle-shaped holes
2
Rack Front
Installing the front end of the rails in a rack with
non-threaded holes.
Pull the rail forward and insert the pins 1 on the
front of the rail into either the square-shaped or
circle-shaped holes on the front of the rack. Drop
the rail down until it latches into place.
Repeat steps 1 and 2 to install the other rail. Make
sure that each rail is securely engaged in the rack.
Go to step 3.
Square-shaped holes
Circle-shaped holes
Advertisement
