Advertisement
2
Installing the rails with the attached adapters in a
rack with threaded holes.
Align the pins on the rear of the rail and attached
adapter with the holes on the rear of the rack; then
install the M4 (L8) screws to secure the rail to the
rear of the rack. Repeat this step for the front of the
rail.
Repeat steps 1 and 2 to install the other rail. Make
sure that each rail is securely installed in the rack.
Go to step 3.
10
3
Removing the rack brackets from the server.
Note: If your server does not come with the rack
brackets, go to step 5.
Loosen the screws and remove the rack brackets
from the side of the server. Go to step 4.
Advertisement
