Advertisement
2
Removing the rack brackets.
Loosen the screws and remove the rack brackets
from the front end of the rails.
3
Rack Front
Removing the front end of the rails with
non-threaded holes.
Note: The non-threaded holes will either be
square-shaped or circle-shaped.
To remove the rails from the front of the rack with
non-threaded holes, push in the lower pin 1 and
lift up slightly on the front of the rail 2 . Remove
the rails from the rack.
Store this information with your server documentation for future use.
18
Rack Front
Removing the rails from a rack with threaded
holes.
To remove the rails from a rack with threaded
holes, remove the screws from the front and rear of
the rails; then, remove the rails from the rack.
Note: If you are removing the rails with
non-threaded holes, go to the section below.
Square-shaped holes
Circle-shaped holes
Removing the rear end of the rails with
non-threaded holes.
To disengage the rails from the rear of the rack with
non-threaded holes, push the middle latch upward
3
Threaded-hole rack
4
Rack Rear
1 and then push back on the rail 2 .
Square-shaped holes
Circle-shaped holes
Advertisement
