Advertisement
For rack with threaded-holes
1
Before installing the rails in rack with threaded
holes, first install the adapters on the front and
rear side of the rails.
Choose one of the rails for installation. Line up the
pins on the front of the rail with the two
circle-shaped holes of the adapter 1 . Push the
adapter so that the pins go into the holes and the
front adapter latches on the rail.
Align the 10-32 (L8) screw 2 with the middle hole
of both the adapter and rail, then install the 10-32
(L8) screw.
Slide the cage nut 3 into the adapter. You may
need to slightly squeeze the cage nut in order to do
so.
Note: For racks that have 10-32 thread, the 10-32
cage nut is not required.
Line up the pins on the rear of the rail with the
three circle-shaped holes on the adapter. Push the
adapter 4 so that the pins go into the holes and
the adapter latches on the rail.
4
4
Installing the rails in a rack with threaded holes.
Align the pins on the rear of the rail and attached
adapter with the holes on the rear of the rack; then
install the M4 (L8) screws to secure the rail to the
rear of the rack. Repeat this step for the front of the
rail.
Repeat steps 1 and 2 to install the other rail. Make
sure that each rail is securely installed in the rack.
Go to step 3.
2
Advertisement
