Avery Dennison ALS 204 User Manual page 37

2 P
RODUCT DESCRIPTION
2.4 F
UNCTION DESCRIPTIONS
An additional material end error is caused, if no
unwinder rotation is detected during at least 600 mm
of material feeding:
Status num: 5072
Material end unw
Materialend warn function:
– Refers to the internal OD control.
– Settings: [Off, „Mat.diam < x mm"]
– Setting range for x = [40,0...500,0]
– Default setting: x = 80
Deactivating the function:
Set x < 40.

Re-activating the function:
Press the key.

Defines the diameter threshold for the material roll.
If the (calculated) material roll diameter is below the
threshold value, the following warning appears:
ONLINE
Material low
Rewinder full function
Defines the maximum permissible diameter of the
wound backing paper on the backing paper
rewinder. If the diameter is exceeded, the following
status message appears:
Status num: 5064
Rewinder full
– Setting range: [50...500] mm; Default setting:
202 mm
37
ALS
20x
256
GB