When To Refill The Rinse Aid Dispenser; Adjusting Rinse Aid Dispenser - Midea MDWFS014LSO Owner's Manual

Table of Contents

Advertisement

When to Refill the Rinse Aid Dispenser

If there is no rinse-aid warning ligh t in the c ontrol panel, you can est imate the am ount from the colour
of the optical level indicator C located ne xt to the cap. When th e rinse-aid c ontainer is full, the whole
indicator will be dark .As the rinse -aid diminishes, the size of the dark dot de creases. You should never let
the rinse aid leve l fall 1 / 4 full.
As the rinse aid d iminishes, the size o f the black dot
on the rinse aid level indicator changes, as illustra ted b elow.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate spotting
Empty
1
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
2
Pour the rinse aid into the dispenser, being careful not to overfill .
3
Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
C lean up any rinse aid spilled w hile during fillin g with an absorbent cloth to avoid excessive foaming
during the next wash. Don't forget to re place the cap be fore you close dis hwa sher door.

Adjusting Rinse Aid Dispenser

Detergents with its chemical ingredients are ne cessary to remove dirt, c rush dirt and transport it out of the di shwasher.
Most of th e co mmerci al qu ality detergents are suitable for this p urpose.
Attention!
Proper Use of Detergent
Use only detergent specifically m ade for the use in dishwashers. Keep your detergent fresh and dry.
Don't put powdered detergent into the dispenser u ntil you're re ady to wash dish es.
" "
The rinse aid dispenser has six or four settings. Always st art with the dispenser
set on "4". If spot s and poor drying are a problem, increase the amount of rinse
aid dispensed by removing the dispenser lid and rotating the dial to "5". If the
dishes still are not drying properly o r are show spots, adj ust the dial to the next
higher lever until your dishes are sp ot-free. The recommended setting is "4".
(Factory value is "4".)
I ncrease the dose if there are drops of water o r lime spots on the di shes after washing.
Reduce i t if there are sticky whitis h stains on your dish es o r a bluish fil m on glassware or
knife blades.

Advertisement

Table of Contents
loading

Table of Contents