Table of Contents
Advertisement
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cann ot be drained dire ctly
into the sink. It will be necessary to drain excess w ater from hoses into a bo wl o r suitable
containe r that is held outside and lower th an the sink.
Water Outlet
Connect the water drain hose. The drain hose mu st be correct ly fitted to avoid water lea ks.
Ensure that the w ater dra in hose is no t kin ked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a sim ilar drain hose.
It must be no longer than 4 metres; otherw ise the cleaning effect of the dishwasher coul d be reduced .
Syphon Connection
The waste conne ction must be at a he ight less than 10 00 mm (maximum ) from the b ottom of the dish.
The water drain hose sho uld be fixed .
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
Fill hose connections are fully tightened and not leaking
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Advertisement
Table of Contents
