Furuno FCR-2139S-BB Installation Manual page 58

2. WIRING
Connection
Note: Fasten the cable shield with the cable clamp.
Input method (MC-3010A only)
Select the method of the analog data input, power voltage or power current.
Note 1: The input must not exceed the range of the input voltage, to prevent malfunc-
tion.
-Setting for voltage input: -10V to +10V or 0 to 10V (depending on the setting)
-Setting for contact input: Voltage 4mA to 20mA.
Note 2: When changing the input method, turn off the MC-3010A and on again to put
change in effect.
2-32
J5 J5
J4 J4
J3 J3
J2 J2
J1 J1
MC1.5-W-L cable MC1.5-W-L cable
J6 J6
J4 J4
J5 J5
J2 J2
J3 J3
J1 J1
MPYC-12 MPYC-12
MC1.5-W-L cable MC1.5-W-L cable
MC-3020D/3030D
For TTYCSLA cables, pass
the drain wire through the
shrink tube, then attach
these crimp-on lugs and
screws to connect drain
wires to here.
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
TTYCS-1/ TTYCS-1/
TTYCSLA-1 TTYCSLA-1
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)