Furuno FCR-2139S-BB Installation Manual page 20

1. MOUNTING
1.3.2 Flush mounting
Use the optional flush mount kit (RCU-025: OP24-24, RCU-026: OP24-27) to mount
the control unit in a console panel.
1. Prepare a cutout in the mounting location as shown in the figure as below.
2. Set the control unit to the cutout.
3. Attach the mounting plate to the control unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex. bolt to each
wing screw.
5. Fasten each wing screw and then fasten the hex. nuts as shown in figure below.
1-10
Control Unit
RCU-025 OP24-24
RCU-026 OP24-27
388+2
For RCU-025
RCU-025
Side view of control units
Flush mount kit
Type
001-171-790
001-171-820
170+2
Code
170+2
110+2
For RCU-026
RCU-026