Marley RR41512 Installation & Maintenance Instructions Manual

Installation & Maintenance Instructions
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered
Products. You have made a wise investment selecting the highest quality product in the heating indus-
try. Please carefully read the installation and maintenance instructions shown in this manual. You
should enjoy years of efficient heating comfort with this product from Marley Engineered Products... the
industry's leader in design, manufacturing, quality and service.
Read Carefully - This instruction sheet contains vital infor-
mation for the proper installation, use and efficient opera-
tion of the heater. Carefully read the manual before instal-
lation, operation, or cleaning of the heater. Failure to
adhere to the instructions could result in fire, electric
shock, death, serious personal injury, or property damage.
Save these instructions and review frequently for continu-
ing safe operation and instructing future users.
RISK OF FIRE, ELECTRICAL SHOCK OR FALLING:
1. To prevent electrical shock, disconnect all power com-
ing to heater at main service panel before wiring or
servicing.
2. All wiring must be in accordance with the National and
Local Electrical Codes and the heater must be ground-
ed as a precaution against possible electric shock.
3. Verify the power supply voltage coming to heater
matches the ratings printed on the heater nameplate
before energizing.
4. This heater is NOT suitable for use in hazardous loca-
WARNING
!
SAVE THESE INSTRUCTIONS
RR41512 & RR53024
Plug-In
Infrared Heaters
... The Employees of
Marley Engineered Products
tions as described by the National Fire Protection
Association (NFPA). This heater has hot and arcing or
sparking parts inside. DO NOT use in areas where
gasoline, paint or other flammable liquids or stored.
5. This heater is intended for ceiling installation ONLY.
The following clearances MUST be maintained:
a) Top of heater to ceiling - 3 in (76 mm).
b) Bottom of heater to floor - 7 ft (2134 mm).
c) Side of heater to wall - 12 in (305 mm).
d) End of heater to wall - 12 in (305 mm).
e) Side of heater to side of adjacent heater - 36 in
(914 mm).
f) End of heater to end of adjacent heater - 36 in (914
mm).
6. Heater MUST be securely fastened to the building
structure to prevent it from falling.
7. DO NOT stack or store combustible materials in the
radiation path under the heater. At least 5 feet (1.5 m)
clearance MUST be maintained between bottom of
heater and combustibles stored.
1