Dual Channel Hookup - AE Techron LVC 5050 Quick Start Manual

Dual Channel Hookup

In Dual Mode, installation is very intuitive: input Channel 1 feeds
output Channel 1, and input Channel 2 feeds output Channel 2. To
activate Dual mode:
1. Turn off the amplifier
2. Wait 10 seconds for the power supply to discharge
3. Slide the Dual/Mono switch to the center position
4. Connect the output wiring as shown below.
The high-current output block has three sets of output connectors per
channel so multiple loads can be easily connected. Two sets accept
banana plugs, while the third set accepts spade lugs or bare wire.
Observe correct load polarity and be very careful not to short the two
outputs.
Page 19