Reading And Processing An Incoming Message - Benefon ESC Owner's Manual

If you wish to delete all the messages displayed in
this list, select the option
-
press . Confirm the deletion by pressing
OK
again, or cancel the operation by pressing
OK
.
NO
READING AND PROCESSING AN
INCOMING MESSAGE
1. Highlight the desired message with
-
press .
SELECT
n
2. By scrolling with
whole message.
3. To process the message, press
•Select the desired function with
-
press .
4. If you do not want to process the message,
.
press to return to the previous menu
QUIT
level.
R e p l y
Use this option if you wish to send a message back
to the sender. That way, you do not need to key in
the phone number or recall it from phone book.
100 GSM MENU: MESSAGES
n
Delete all with
n
, and
, you are able to read the
-
SELECT.
n
Write and edit the text as follows:
and
•To remove letter(s), press
-
.
•To add letters into text, press
•To add special characters into text, press
a few seconds. Use
press the numeric key, which corresponds to the
desired character.
•To enter a space, use
•To move inside the text, press
•You may also modify the text with the T9 text
input tools (for further information about using
the T9 text input, please see the chapter Main
menu, Accessories, Notepad, Writing a note in
T9 mode).
and
When the message is written, press
send, save or postpone it.
If you do not want to go further, press
cancel the operation and return to the message
processing list.
Sending and saving the message
You have four options to choose from: send and
save, send only, send with position, and postpone.
Select an option with UBER-1017 - Page 106
.
shortly.
CLEAR
2 9
... .
n
to select a line and then
+
.
n
.
-
SELECT
.
QUIT
n -
and press .
OK
0
for
to
to