Installation Steps; Wiring - Danfoss BasicPlus2 WT-D Installation Manual

Room thermostats
Table of Contents

Advertisement

Installation Guide

1. Installation Steps

User Guide can be downloaded from: heating.danfoss.com.
1. Installation must be done by an authorised
electrician.
2. The room thermostat should be installed at approx.
1.5 m above floor and where the effects of sunlight,
draught or other heat sources (eg. TV's) are avoided,
see fig. 1.
3. First of all, carefully remove the cover, see fig. 2.
4. Connect the wire before mounting the back plate to
the wall box using the enclosed screws. Then mount
the cover to the back plate, see fig 3.

2. Wiring

Dimensions, see fig. 4. Wiring diagram, see fig. 5 (S1, S2:
floor sensor terminals).
WT-D/P is often used with Danfoss TWA actuator.
Depending on the conditions of power location and
actuator type (NC or NO), the wiring between room
thermostat and actuator is different.
Follow the illustrations to complete the wiring:
1. When power supply location is close to room
thermostat:
• Connect to actuator TWA 230 V NC type,see fig. 6.
• Connect to actuator TWA 230 V NO type, see fig. 7.
2
BasicPlus
WT-D & WT-P
2
VICUJ212
Danfoss Heating Solutions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BasicPlus2 WT-D and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Basicplus2 wt-p

Table of Contents

Save PDF