Installation And Start-Up; Installation - Circutor CVM-144 (HAR) User Manual

-- Supply network analyzer CVM-144 (HAR) ----- User's manual ---

4.- INSTALLATION AND START-UP

The manual you hold in your hands contains information and warnings
that the user should respect in order to guarantee a proper operation
of all the instrument functions and keep its safety conditions. The
instrument must not be powered and used until its definitive assembly
on the cabinet's door.
If the instrument is not used as manufacturer's specifications, the
When any protection failure is suspected to exist (for example, it presents
external visible damages), the instrument must be immediately powered off. In this
case contact a qualified service representative.

4.1.- Installation.

Before powering the instrument for the first time, verify following points:
Power supply: see rear part of your CVM-144
a.-
Standard supply :
SDC Model
On request: other voltages
protection of the instrument can be damaged.
- Frequency
- Supply voltage tolerance : - 10 % / + 15
- Connection terminal
- Burden
- Supply voltage tolerance : - 20 % / + 15
- Connection terminal
- Burden
Single-phase 230 V
: 50 - 60 Hz
: Terminals 1 - 2 (Power supply)
: 5 VA
: 0.24.... 120 V c.c. ( continua )
: Terminals 1 - 2 (Power supply)
: 2,2 W
Page No. 6
∼
(a.c.)