Whirlpool SPIW409A2WF Instructions For Use Manual page 65

How much is the distance from router to
the appl. (one room / two room)?
Is there anything that can prevent the
signal to reach the appliance?
What can I do if my wireless connections
does not reach the air conditioner?
I changed the router, what do I have to do?
What can I do if the Connection State
indicator continues to blink slowly and
never lits solid on?
Where do I find the MAC address of the
air conditioner?
How to set up the wireless connection on
your appliance?
How to check if data is being transmitted?
The manufacturer, Whirlpool EMEA S.p.A., declares that this SPIW309A3WF, SPIW312A3WF,
SPIW409A2WF, SPIW412A2WF Model of household appliance with radio equipment Amber Wifi
Module is compliant with directive 2014/53/UE
The complete text of declaration of conformity is present at the following website:
https://www.whirlpool.eu
Normally the coverage is for few rooms but WiFi signal is
strongly dependent to wall materials.
• If air conditioner wifi is off, customer can check
connection strength with tablet (or other Wireless HAN
devices) close to appliance (for example specific software
tools downloadable from internet to check signal
strength).
Verify not having connected some devices using together all
the internet bandwidth and make sure that all the internet
home devices don't overcame the router max limit device
connected.
You can use specific devices to extend the home WIFi
coverage as: Access Point, WiFi repeaters and Power-line
bridge (not provided with air conditioner).
You can either maintain the same set up properties
(network name and password) or erase the previous set up
from the appliance (reset process) and carry out the setup
again (see "Live-Remote Control/Setup procedure").
If the wifi Connection State indicator doesn't lit up solidly,
the air conditioner has been successfully connected to the
router, but it is not able to connect the Internet. In order to
get the appliance connected to the Internet, you have to
check the router and/or the bearer settings.
Correct router settings: NAT must be on, Firewall and
DHCP must be properly set. Password cryptography
supported: WEP , WPA,WPA2. Please refer to router manual.
Bearer settings: if Your Internet service provider has
established the numbers of MAC address able to connect to
the Internet, you may not be able to connect air conditioner
to the cloud. The MAC address is the unique identifier of
device, e.g the one of your computer. Please ask your
Internet service provider about the procedures to connect a
new device other then a computer ( e.g a air conditioner) to
the Internet.
On your Smart Appliance: • on the air conditioner there is
sticker label with SAID & MAC address The MAC address is
made by combination of numbers and letters.
See detailed IFU, there are 2 alternative approach on each
appliance: 1. use the WPS (WiFi Protected Setup)
connection process. 2. If the appliance is not Provisioned, in
the first 20 minutes from appliance switch on it is active a
web page for configuration accessible through the network
generated by the appliance (WP_"MAC Address", example
AIRCON_88_E7_12_00_28_3C).
After network setup power off, wait 20 sec and power on
the appliance, verify that the App shows the UI status of the
appliance. Set Jet or another option and verify on the App
the status (NOTE: temperature setting takes several
seconds before it is delivered to the App).
65