Table of Contents
Advertisement
Canopy
2x8mm
Receiver / Battery
Move the location of the receiver and battery pack
as needed to obtain the specified CG.
Carefully install the receiver and battery pack to
ensure that they will not move during flight.
Control Surface Movement
90~ 100mm
AILERON
30mm
30mm
RUDDER
•This model aircraft is designed for Intermediate to Experienced fliers. Beginners should seek advice for pre-flight adjustments and assembly
from more experienced fliers. Be aware that flying a badly assembled or badly adjusted aircraft is very dangerous!
•At the start, first-time fliers should always be assisted by an experienced flier and NEVER fly alone!
•This model aircraft is designed to be powered by either a 2 stroke .40 ~ .46 size engine or a 4 stroke .48 ~ .53 size engine. Installing a more
powerful engine than specified or flying this model dangerously could lead to serious injury and/or damage to property.
Cut off shaded portion.
Must be purchased separately!
14
For the correct location of decals,
please refer to the next clause.
Foam Pad
CG
ELEVATOR
Drill holes with the specified
diameter (here: 2mm).
Assemble left and right sides
the same way.
Decal
(Cockpit panel)
Never fly before checking the CG's required position.
Adjust the travel of each control surface to the
10mm
values in the diagrams.
10mm
These values fit general flight capabilities.
Readjust according to your requirements
and flight experience.
15mm
15mm
Pay close attention here!
Paint.
2 x 8mm
TP Screw
4
Secure foam padding with
rubber bands or tape as required.
Do not overlook this symbol!
Advertisement
Table of Contents
