2-6
Tower Mounting Instructions
The SC747 chassis is shipped with the chassis cover and feet pre-installed. To use
the chassis as a desktop workstation, no other installation is required.
Use the instructions in this section if you have converted the chassis for rack use
and need to return the chassis to tower mounting.
Figure 2-6. Adding Chassis Feet and Top Cover
Chassis Cover
Installing the Chassis Cover
Installing the Cover
1. Remove the rack mount ears.
2. Align the cover post with the corresponding holes on the top of the chassis
and place the cover on top of the chassis. The cover should overhang
approximately one-half inch over the front of the chassis.
3. Slide the chassis cover toward the rear of the chassis to lock the cover into
place.
Warning: When initially installing the server to a rack, test that the rail
locking tabs engage to prevent the server from being overextended. Have
a rack lift in place as a precaution in case the test fails.
Slide rail mounted equipment is not to be used as a shelf or a work space.
Chapter 2: Workstation Installation
Chassis Rackmount Ears
2-9
Chassis Feet