Table of Contents
Advertisement
Update Firmware Using an SD Card
Install Firmware Installation File
The following process can be done by removing the SD card from the receiver, or connecting to it using FTP,
TRU, or TopNet+.
1. Connect to the receiver or remove the SD card, and insert it into a computer.
2. Locate and open the b310 sub-folder on the SD card.
3. Verify that a b310.update folder is present. If not, create the folder.
4. Locate and copy your *.tar firmware installation file to the b310.update folder.
5. If you removed the SD card from the receiver in Step 1, insert the card into the receiver. Otherwise,
disconnect from the receiver.
Begin Firmware Update
Open the GRIL terminal and send the command
complete. During installation, the Power LED will blink yellow-green. After installation, the Power LED will be
solid green. Once the Power LED is solid green, connect to the receiver using TRU and verify that the correct
firmware is installed (see "Verify Firmware Upload" on page 23).
About the OAF
Topcon issues an Option Authorization File (OAF) to enable the specific options that you purchased. Topcon's
OAF system allows you to customize and configure the receiver according to your particular needs, therefore
purchasing only the options you require.
The Net-G5 receiver typically ships with an OAF as per initial purchase of the receiver kit configuration. There
are several upgrade options available with the receiver that can extend the receiver's functionality to better suit
your job requirement. Examples of upgrade options are listed below:
Standard Options
•
GPS
•
GLONASS
•
GPS + GLONASS dual frequency static operation
•
GALILEO
•
BeiDou
•
QZSS
•
50HZ
•
100HZ
•
Additional external frequencies
•
Contact your Topcon dealer or a representative for a complete listing of available options and pricing
information.
About the OAF
%%set,update,yes
. The update will take up to 10 minutes to
P/N: 1004636-01
24
Hide quick links:
Advertisement
Table of Contents
