Troubleshooting; Disposal; Manufacturer's Warranty - Tools - Hilti SD 5000 Operating Instructions Manual

9. Troubleshooting

Fault
The power tool doesn't start.
The power tool doesn't achieve
full power.
The spindle doesn't rotate.

10. Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment
and its implementation in accordance with national law, electric tools that have reached the end
of their life must be collected separately and returned to an environmentally compatible recycling
facility.

11. Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070554 / 000 / 00
Possible cause
Interruption in the electric supply.
Supply cord or plug defective.
The control switch is defective.
The extension cord's conductor
cross section is inadequate.
The control switch is not pressed
fully.
No axial pressure applied.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Remedy
Plug in another electric appliance
and check whether it works.
Have the supply cord and plug
checked by an electrical specialist
and replaced if necessary.
Have the supply cord and plug
checked by an electrical specialist
and replaced if necessary.
Use an extension cord with an
adequate conductor cross section.
(Please refer to "Description".)
Press the control switch as far as it
will go.
Apply axial pressure to the drive
spindle.
en
25