Printing A Report; Saving And Retrieving Measurements; Quick Test - NDD EasyOne Operator's Manual

EasyGuide
On the printed report, parameters that are below the lower limit of normal (LLN) are printed in red and
marked with an asterisk (*). EasyOne
Chapter 11 for further information on this interpretation.
It is possible to deactivate both the QC-Grade function and the Interpretation function.
5.5

Printing a Report

You will require a base unit and a compatible printer in order to print a report directly from EasyOne .
With base unit or Screen Connector reports can also be printed via a PC using the software EasyWare.
The type of printing and additional print option can be set in the Printer Settings of the CONFIGURATION
menu (see chapter 8.3).
Immediately after completion of the test, you have the option of printing by selecting the PRINT field
and confirming this with ENTER. You will see message "Please connect device to cradle". Insert the in-
strument into the cradle and wait until the print job has been printed. EasyOne
signal indicating when the instrument can be removed.
You can also print old tests. To do this, select option Print Results , Single Test in the main menu,
choose the required test with key (>) or (<) and press ENTER. You can also print a number of tests at
once by choosing Print Results , Range of Tests and entering a start and end date. You will once
again see message "Please connect device to cradle ".
Depending on the type of printer, it will take between 30 and 90 seconds to print out the report. Should
you have problems printing out, please refer to the information in Chapter 15.
During PictBridge printing the following 4 icon groups show the status of the printing process:
Printer Activity
Printing
Idle
Paused
5.6

Saving and Retrieving Measurements

EasyOne saves all test results automatically. No data is lost even if the batteries are removed. The
oldest test is overwritten when the memory is full (up to 700 measurements).
You can recall saved measurements for the purpose of conducting a new test with the same patient,
adding maneuvers, adding a post-test, viewing results, or printing results. You can add a maneuver or a
post-test only on the same day that the original test was performed. See Chapters 9.5 and 9.6.
In order to add a test to an old measurement, choose Perform Test in the main menu and then
choose RECALL. Follow the rest of the instructions.
In order to view an old test, choose View Results in the main menu and choose the desired test.
5.7

Quick Test

You have the option to perform a quick test without entering patient data. Select Perform Test in the
main menu and then QUICK. Choose the desired test using the arrow keys and press ENTER.
Please note:
also offers an automatic interpretation aid. Please refer to
Job End Status
Not ended
Ended normally
Aborted
Other reason
When Quick Test is selected, no comparison to predicted normals are dis-
played or printed. Predicted normals are only available when age, height and
gender are entered.
Error Type Error reason
No error
Warning
Fatal error
issues an audible
No reason / No error
Check paper supply
Check ink cartridges
General printer problem
Printer cannot read report file
Page 11