Specifications; Ec Declaration Of Conformity - Makita JS1660 Instruction Manual

ENGLISH (Original instructions)
1-1. Slide switch
2-1. Screw
2-2. Screwdriver
3-1. Center blade

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
3-2. Bolt
3-3. Hex wrench
3-4. Side blade
4-1. Pin
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
-1
)
Overall length
Net weight
Safety class
) : 84 dB(A)
pA
) : 95 dB(A)
WA
2
) : 8.0 m/s
h
2
JS1660
2
1.6 mm (16 ga.)
2
1.2 mm (18 ga.)
2
0.8 mm (22 ga.)
2
2.5 mm (13 ga.)
4,500
304 mm
1.4 kg
ENE037-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENF002-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG102-3
For European countries only

EC Declaration of Conformity

We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
ENG218-2
Straight Shear
Model No./ Type: JS1660,JS1670
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
ENG901-1
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
7-1. Limit mark
8-1. Screwdriver
8-2. Brush holder cap
---
/II
Corporation as
JS1670
1.0 mm (20 ga.)
0.7 mm (23 ga.)
0.5 mm (26 ga.)
2.5 mm (13 ga.)
30 mm
4,500
306 mm
1.4 kg
/II
ENH101-14
the responsible