2Quad Copter; Quadcopter Motor Led Indicator; 3Quadcopter Battery; Introduction - UBSAN H501A User Manual

2.Quadcopter
1 Propeller B
6 Lower Body Shell
[10]
Rubber Feet

2.1 Quadcopter motor LED indicator

Front LED is blue; Back LED is red.
1.Power on: 4 LED indicators blink simultaneously.
2.Compass Calibration:
1). Horizontal calibration: 4 LED indicators blink circularly.
2). Vertical calibration: 4 LED indicators blink alternately .
3.Quadcopter Horizontal Calibration: 4 LED indicators blink slowly.
4.Quadcopter Rotation Calibration: 4 LED indicators blink circularly.
5.GPS Flight: 4 LED indicators will remain solid.
6.Low Voltage Return : 2 front LED indicators remain solid, and 2 back LED indicators blink
quickly.
7.Signal Lost: 2 front LED indicators blink alternately, 2 back LED indicators remain solid.
8.LED indicators can be turned off by long pressing the lower throttle trim on the transmitter.

3Quadcopter battery

3.1 Introduction

The quadcopter battery is a rechargeable Li-Po battery with 2700mAh capacity and 7.4V
voltage.The battery should only be charged with Hubsan charger to avoid overcharge.
3.2 Installing the battery
Push the battery into the battery compartment (as shown below) and connect the battery
cable with the correct polarity then close the battery compartment cover.
2 Propeller A 3 Motor
7 1080P Camera
X-Hubsan H501A
4 LED Light
8 Battery Compartment
Please make sure the battery is fully
charged before the first time use.
5 Upper Body Shell
9 TF Slot
5