Advertisement
Step 4: Attach cables
1. Connect the appliance to your network by plugging the network cable to
the appropriate Ethernet port and then into your network.
Symbol
1
2
2. Connect the power cable to the receptacle on the back of the appliance and
then to a power source outlet.
3. Continue with "Step 5: Power on and verify LED status".
Step 5: Power on and verify LED status
1. Wait at least 20 seconds after connecting the power cable before powering
on the appliance. Power on by pressing the Power button on the front of
the appliance.
2. Wait at least 3 minutes after power on for the initial diagnostics to
complete, and then verify that the Power LED and LAN 1 or LAN 2 LED
are ON. If not, refer to the IBM TotalStorage NAS 100 User's Reference on the
Documentation CD.
4
NAS 100 Quick Start Instructions
Ethernet Port
LAN 1
LAN 2
1
2
System Uses
DHCP
Static IP
Advertisement
