Troubleshooting Guide - Ideal Security SK662 Manual

TROUBLE SHOOTING GUIDE
AUTO-DIALER WILL NOT ARM/DISARM USING THE KEYPAD
• Make sure you have entered the correct password, if not, re-enter the password.
• If it still does not work, perform the password reset following the instructions in the "CHANGE PASSWORD" section to
reset the auto-dialer.
• Retry the ARM/DISARM function.
AUTO-DIALER WILL NOT DIAL
• Make sure the telephone line is connected properly.
• Make sure the telephone numbers are stored correctly.
• Make sure the auto-dialer is setup for auto-dial mode.
• If auto-dialer does not receive a signal from the wireless sensor, re-link the sensor to the dialer following the instructions
in the "LINKING WIRELESS SENSORS TO THE AUTO-DIALER" section.
FALSE OR NO TRIGGERS
• If The water sensor sends false signals ensure that the batteries are still in good operating condition.
• If The water sensor sends no signals when wet make sure that the metal contacts on the sensor are not corroded. Gently
scrape the contacts with a sharp knife to expose clean metal.
TIPS
• DO NOT program 911 to the dialing sequence of the auto-dialer.
• Make sure full telephone numbers have been entered correctly.
• Only suitable for single phone line. Not compatible with fax machines or multi line telephones.
• Auto Dialer requires a land line and tone dialing
WARNING
All batteries including the back up battery in the telephone dialer should be changed at minimum once per year as the battery
in smoke detector is changed. Should a power failure occur and the back up battery is weak, or batteries in any of the sen-
sors are weak, false alarms may occur. If the telephone dialer or any other detector is not being used for an extended period,
remove the batteries to avoid any damage from battery leakage.
Scratch the 2 metal contacts 4-5 times
Grattez les 2 contacts de métal 4 à 5 fois
Contacts / Capteurs