Ideal Security SK662 Manual page 4

To wall socket
• Wall mount option: Choose a suitable location where you have access to a telephone line and electrical outlet,
drill holes using template provided and install anchors and screws. Place the auto-dialer over the screws and slide
it down to secure it in place.
AUTO-DIALER SET-UP
NOTE: If no key is pressed for 20 seconds, the auto-dialer will automatically exit set-up mode.
• Set-up is done in DISARM mode only.
• The auto-dialer has a factory preset password of 0-0-0. This should be changed to your own personal password.
1. TO CHANGE PASSWORD
• Enter factory pre-set password 0-0-0. Press PROG button once (1), PASSWORD will flash on the auto-dialer screen.
• Press the ARM/DISARM button to confirm that you want to enter the PASSWORD.
• Enter your new password then press the ARM/DISARM button to confirm your new password has been stored
(you can choose from 3 to 6 digits for your password).
• Press the PROG button nine (9) times to exit set-up mode.
NOTE: PASSWORD RESET
If you forget your password, locate the RESET button on the back of the unit. Press and hold the PROG button, and, press
and release the reset button once. The screen will go blank. When screen returns let go of the PROG button. You now have
the factory pre-set password of 0-0-0. This will reset the password ONLY, all other information will remain (programmed
telephone numbers and learned sensors).
2. RECORD PERSONALIZED NOTIFICATION MESSAGE
You can record a single personalized 20 second message that will be played back when you receive telephone notification
that your system has been triggered. To help remember the options you have, your message should be similar to:
"The Water Detector at [address] has been triggered, please enter a command; to Disarm System and end call press 6 and #,
to End Call press 3 and #, to Monitor Room press 1 and #, to Broadcast press 2 and #".
• Enter password then press REC/PLAY once.
• Clearly and slowly dictate your 20 second message.
• Press REC/PLAY to end recording. The recording will automatically end after 20 seconds. The message will replay once
after recording is finished.
• Press REC/PLAY to replay message at anytime.
3. SETTING THE TIME (YEAR / MONTH / DATE / HOUR / MINUTES)
• Enter password then press the PROG button nine (9) times.
• Will flash on the auto-dialer screen.
• Press ARM/DISARM button to confirm.
• The date will show on the auto-dialer screen as five sets of numbers: year, month, and date followed by the time hour and
minutes (24 hr. time clock). The first set of numbers will flash confirming that these can now be changed.
• Enter correct year by pressing */UP or #/DOWN button, then press the ARM/DISARM button. The next set of numbers will
start flashing, enter the month by pressing */UP or #/DOWN button, then press the ARM/DISARM button. Continue until
you have the correct date and time.
• Press PROG button once (1) to exit set-up mode.
4. TO PROGRAM EMERGENCY TELEPHONE CALL NUMBERS
• Enter password followed by PROG button twice (2).
• MEMORY will flash on the auto-dialer screen.
LINE TEL.
(LINE) (TEL.)
To telephone
( Fig. 3a )
LINE TEL.
DC 9V Adaptor
( Fig. 3b )