Ideal Security SK662 Manual page 6

10. TO PROGRAM CALL-IN RING DETECT CYCLE (how many rings before auto-dialer will answer).
The auto-dialer has been factory preset to answer after the 5th ring. The call-in ring detect cycle is for how many times you
want the phone to ring before the auto-dialer picks up. You can arm/disarm and monitor your home via the telephone.
• Enter the password followed by the PROG button seven (7) times.
• The " " symbol will flash on the screen.
• Press ARM/DISARM button to confirm.
• Using the */UP and #/DOWN buttons select 3, 5, 7 or 10 (which represents the # of rings before the auto-dialer picks up)
followed by the ARM/DISARM button to confirm.
• Press the PROG button three (3) times to exit set-up mode.
NOTE: You cannot use an answering machine with this feature. If you want to be able to call in to the auto-dialer you must
program it to answer before your answering machine does. Example if your answering machine answers after 4 rings,
you must set the auto-dialer to answer at 3 rings.
11. TO PROGRAM INTERNAL 105 dB AUTO-DIALER SIREN ON/OFF
The auto-dialer has been factory pre-set with the siren ON. To change this to OFF:
• Enter password followed by PROG button four (4) times.
• The " " icon will flash on the auto-dialer screen. (Fig. 8)
• Press ARM/DISARM to confirm.
• Using */UP or #/DOWN buttons to select SOUND OFF.
• Press ARM/DISARM button to confirm.
• Press PROG button six (6) times to exit the set-up mode.
12. TO PROGRAM ENTRY DELAY TIME: (Time allowed to deactivate system once you have entered your residence)
The auto-dialer has been factory pre-set with a 20 second delay. To change the delay time to 0, 5, 10, 15 or 20 seconds:
• Enter password followed by PROG button eight (8) times.
• "ENTRY" will flash on the auto-dialer screen.
• Press the ARM/DISARM button to confirm.
• Using the */UP and #/DOWN buttons select the seconds 0,5,10,15 or 20
• Press ARM/DISARM to confirm the number of seconds you require for the entry delay time.
• Press the PROG button twice (2) to exit set-up mode.
INSTALLATION OF THE WATER SENSOR
Before installing Sensors permanently you should test the signal range. Transmission distance from sensors to the
auto-dialer is approximately 60 meters (200'). Using HOME MODE is a convenient way to test Sensors and Remotes.
In HOME MODE the auto-dialer will function only as a chime. Press the HOME button on the keypad of the auto-dialer,
wait 60 seconds you will hear a beep, trigger the sensor by dipping it in water. The auto-dialer will receive a signal and a
chime will sound. If you do not hear a chime and the zone is not flashing on the auto-dialer screen, the sensor may be out of
range. Repositioning either the sensor or auto-dialer should fix this problem. Press HOME button again to exit test mode.
DESCRIPTION OF COMPONENTS
1. Wireless Transmitter
2. Water Sensor
3. Battery low / Trigger LED
4. Alarm ON - OFF switch
5. Battery compartment
INSTALLATION
• Remove cover from back of unit and install supplied 9V battery (fig.I)
• Determine spot for the sensor. Do not place directly on humid concrete as this may trigger false alarms.
Place sensor flat or use suction cup if surface is smooth.
• Turn the unit to ON. Wait for alarm activation BEEP (standby mode). Test the sensor with some water.
• The Water Sensor is factory linked to zone 1. When triggered zone 1 will flash on the auto-dialer screen.
• Mount the alarm at desired height with screws provided.
3
2
6'
1.8 m
1
4
5