To Add Or Change A Keyless Entry Pin (Optional) - Chamberlain ATS2113X 1/2 HP Installation Manual

To Add or Change a Keyless Entry PIN (Optional)

NOTE:
Your new Keyless Entry must be programmed to operate your door operator.
USING THE "LEARN" BUTTON
1. Press and release the "LEARN"
button on motor unit. The learn
indicator light will glow steadily
for 30 seconds.
2. Within 30 seconds, enter a four
digit personal identifi cation
number (PIN) of your choice on
the keypad. Then press and hold
the ENTER button.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and
hold the # button.
The operator light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then press
ENTER.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press ENTER. The door
should move.
To set a temporary PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours
or number of accesses, this temporary PIN expires and will
no longer open the door. It can be used to close the door even
after it has expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN
(not the last temporary PIN), then press and hold the ✽
button.
The operator light will blink three times. Release the ✽
button.
2. Press the temporary 4-digit PIN you have chosen, then
press ENTER.
The operator light will blink four times.
3. To set the number of hours this temporary PIN will work,
press the number of hours (up to 255), then press ✽.
3. To set the number of times this temporary PIN will work,
press the number of times (up to 255), then press #.
The operator light will blink once when the temporary PIN has
been learned.
Test by pressing the four buttons for the temporary PIN,
then press ENTER. The door should move. If the temporary
PIN was set to a certain number of openings, remember that
the test has used up one opening. To clear the temporary
password, repeat steps 1-3, setting the number of hours or
times to 0 in step 3.
30
OR