Setup Of The Double Matrix Professional Sonic - Clearaudio Double Matrix Professional Sonic User Manual

Record cleaner
Hide thumbs Also See for Double Matrix Professional Sonic:
Table of Contents

Advertisement

Available languages

Available languages

Double Matrix Professional Sonic
User manaul
Bedienungsanleitung
Double Matrix Professional Sonic
3. Setup of the
Double Matrix Professional Sonic
Take the already assembled
record cleaning machine from its packaging.
Set it on a stable and horizontal surface (such as a desk or rack).
Please note that due to the weight of the record cleaning machine, the feet of the device can cause marks
Double Matrix Professional Sonic
on soft surfaces. Due to the warm air outlet on the bottom of the
, the
surface on which it rests should be heat resistant to a minimum of 60°C.
3.1 Connect to the mains supply
Double Matrix Professional Sonic
To avoid using an additional extension cable, place the
within 2 metres of
an electrical wall outlet.
Double Matrix Professional
Connect the supplied mains cable first to the IEC socket on the back of the
Sonic
, and then to the electrical wall outlet. Press the switch on the IEC socket and position it to "I".
Using the funnel supplied, fill the cleaning fluid reservoir with cleaning fluid. Pay careful attention to
Pure
the fluid level LED indicator to avoid over-filling. For best results we recommend using Clearaudio
Groove
cleaning fluid. Close the cleaning fluid reservoir with the cap.
Double Matrix Professional Sonic
Now the
is ready for use. Please read the whole user manual before
cleaning your first record.
Note: Voltages are referenced to EU countries with 230V mains power.
In other countries the mains voltage and frequency may vary (e.g. USA 115V/60Hz.)
The correct operating voltage can be found on the back of the device on the product
information label (Fig. 1).
Pic. 1: Product information label on the back
The mains cable supplied should be of the type appropriate for your country. Please ensure that the mains
voltage of your country also matches the mains voltage of the device. This information is also on the
product information label (see above). If it does not match, contact your Clearaudio dealer.
Page /Seite 6
© clearaudio electronic GmbH 2017

Advertisement

Table of Contents
loading

Table of Contents