Troubleshooting Guide - Stanley POP PB3400 Instruction Manual

E N G L I S H

39. Troubleshooting guide

y S m p o t m
Tool stops before rivet is fully set
Tool does not return to initial
position when switch is released.
Tool does not operate when switch
is pressed.
*Reset tool to home: quickly pull & release the switch
22
C a u e s
Setting load of rivet is beyond tool
capacity.
Improper nosepiece selection.
Battery pack has reached operating
temperature limit through
continuous use or defect.
Electrical malfunction.
Battery is not fully seated
Battery is not fully charged
Battery pack has reached operating
temperature limit through
continuous use or defect.
Battery is defective
R e m e d y
Reset tool to home, remove rivet &
use appropriate tool to set rivet.
Reset tool to home, remove rivet &
fit proper nose piece.
Remove battery & allow to cool.
Mount battery and reset tool to
home.
Remove battery, wait 5 seconds and
reinsert. Reset tool to home.
Remove battery and re-insert. Reset
tool to home.
Charge battery
Remove battery & allow to cool.
Mount battery and reset tool to
home.
Replace battery