Table of Contents
Advertisement
5 Installation
5-3
Mount
This section describes how to mount the Industrial Panel PC in either a landscape or portrait orienta-
tion in a control panel.
Ensure that installation and post-installation checks of the product are
performed by personnel in charge who possess a thorough understand-
ing of the machinery to be installed.
5-3-1
Installation Method in Control Panels
The Panel PC must be mounted to the outside surface of a control panel.
Consider product orientation, cooling distance, noise resistance, ducts and product replacement when
determining the space between the Panel PC and other devices.
Precautions for Safe Use
Install the product in the correct orientation and temperature according to the specifications in
the manual to prevent overheating. Not doing so may result in malfunction.
Precautions for Correct Use
Do not operate or store the product in the following locations. Operation may stop or malfunc-
tions may occur.
• Locations subject to direct sunlight
• Locations subject to temperatures or humidity outside the range specified in the specifica-
tions
• Locations subject to condensation as the result of severe changes in temperature
• Locations subject to corrosive or flammable gases
• Locations subject to dust (especially iron dust) or salts
• Locations subject to exposure to water, oil or chemicals
• Locations subject to shock or vibration
• Locations outdoors subject to direct wind and rain
• Locations subject to strong ultraviolet light
Additional Information
• Ensure you have installed the options before you mount the product.
Refer to 5-2 Install Options on page 5 - 5 for option details.
• Refer to 5-3-2 Product Orientation on page 5 - 15 for orientation details.
• Refer to 5-3-3 Temperature on page 5 - 16 for temperature details.
• Refer to 5-3-4 Humidity on page 5 - 18 for humidity details.
• Refer to 5-4 Wire on page 5 - 27 for wiring details.
5 - 14
WARNING
NY-series Industrial Panel PC User's Manual (W555)
Advertisement
Table of Contents
