Location And Connection; Setup And Operation - EUROM Safe-t-heater 1500 Instruction Booklet

20. Close supervision is necessary when the product is used near children or incapacitated persons. Do not let
children use the appliance as a toy. This appliance is not suitable to be operated by children or persons who
have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience with,
this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of overheating.
Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or plug, if the appliance is
malfunctioning, if it has been dropped or when there are signs of any other defect. Return the complete product
to the vendor or to a certified electrician for inspection and/or repair. Always ask for original parts.
23. Do not use attachments and/or accessories that have not been recommended or supplied by the manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
1 – Thermostat dial
2 – Mode selector dial
3 – Rotation dial
4 – Heating grill
5 – Front panel

Location and Connection


Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not use
the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal surface.

Check if the mode selector dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To prevent the circuit overloading, check
that no other appliances are connected to the same group.
Set-up and Operation

Switch the heater on by turning the mode selector dial to one of three
positions. The light at the front will turn on.
500 = Heating at 500W
1000 = Heating at 1000W
1500 = Heating at 1500W

The thermostat serves to maintain a constant room temperature. To set the desired temperature, turn the
thermostat dial to its maximum position (clockwise as far as it goes). Set the mode selector dial to 500, 1000 or
1500. Once the desired temperature is reached, turn the thermostat dial back slowly until you hear a click. This
causes the heater to switch off. The heater will now automatically switch on and off to maintain the set
temperature.

The pressure switch between the thermostat and mode selector dial turns on the oscillating function. Push in to
operate the oscillating function and push again (to release) and the function will switch off.

To switch the heater off, first turn off the oscillating function off, then set the power dial to '0' (off). Unplug.
10