Location And Connection - EUROM Q-time 2001 Instruction Manual

Deviations of points <5>, <6>, and/or <7> can cause damage, fire
and/or personal injury. This cancels the warranty and the
manufacturer, importer and/or supplier do not accept any liability for
the consequences.
Description
1. Heating element (2x) quartz
2. Peep hole
3. Pull switch

Location and connection


Remove all packaging material and keep out of reach of children. Pay attention
to the mounting material!

After removing packaging, check the appliance for damage or other signs that
could indicate a fault/defect/malfunction. In case of doubt, do not use the
appliance, but contact your vendor for inspection or replacement.

Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.

This heater has been designed to be hung horizontally from a wall; therefore do
not use it whilst it is standing, lying or in any other way!

Pay attention to the mounting place for your heater. The appliance has to be
mounted on an incombustible foundation. That foundation has to be vibration free,
exact vertical and stable enough for lastingly holding the appliance free of
problems. Check or the provided dowels and screws are suitable, strong enough
and qualified for the foundation. The material provided is identified for a brick
wall; for another foundation please ask the specialist for suitable material.

Before mounting, check whether the spot you have chosen complies with the
minimum safety distances from the environment. The distance between the
bottom side of the heater and the floor must be at least 1.8 metre. The distance
between the top side of the heater and the ceiling, roof, etc. must be at least 0.3
metre. However, if the ceiling or roof is made of flammable material (e.g.,
canvas), then the minimum distance is 1 metre. On both sides of the appliance,
the minimum distance to walls, etc. must be 0.5 metre. If you mount the
appliance outdoors, then make sure that it is not situated where it gets direct
wind.

The insulation of the Q-time 2001 is IP24 rated (splash proof). A distance of at
least 1 m has to be maintained between the heater and baths, taps, fountains,
32