Toshiba TECRA A8 series Maintenance Manual page 94

2 Troubleshooting Procedures
Procedure 2
Insert the Diagnostics Disk in the USB FDD, turn on the computer and run the test. Refer to
Chapter 3, Tests and Diagnostics, for more information about the diagnostics test procedures.
Floppy disk drive test error codes and their status names are listed in Table 2-5. Make sure
the floppy disk is formatted correctly and that the write protect tab is disabled. If any other
errors occur while executing the FDD diagnostics test, go to Check 1.
Check 1
Check 2
2-46
Downloaded from www.Manualslib.com
Diagnostic Test Program Execution Check
Table 2-5 FDD error code and status
Code
01h Bad command error
02h Address mark not found
03h Write protected
04h Record not found
06h Media removed
08h DMA overrun error
09h DMA boundary error
10h CRC error
20h FDC error
40h Seek error
60h Not drive error
80h Time out error
EEh Write buffer error
FFh Data compare error
If the following message appears, disable the write protect tab on the floppy disk.
If any other message appears, perform Check 2.
Write protected
Make sure the floppy disk is formatted correctly. If it is, go to Procedure 3.
[CONFIDENTIAL]
manuals search engine
Status
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
2.5 USB FDD Troubleshooting