Toshiba TECRA A8 series Maintenance Manual page 307

4.25 LCD unit/FL inverter
Installing the LCD unit/FL inverter
To install the LCD unit/FL inverter, follow the steps below and refer to Figure 4-37 to 4-40.
1. Connect the LCD cable to the connector on the back of the LCD unit. Stick two glass
2. Install the LCD unit to the display cover and secure it with the following screws.
3. Arrange the LCD cable through the hook and connect the LCD cable to the
4. Connect two cables to the FL inverter and install the FL inverter in place.
5. Insert the insulator under the LCD unit.
6. Install the LCD mask while engaging the latches.
7. Secure the LCD mask with the following screws and stick the mask seals.
8. Install the keyboard cover while engaging latches.
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
Downloaded from www.Manualslib.com
tapes in place.
•
M2×3C BIND screw
connector CN5000 on the system board.
•
M2.5×6B FLAT HEAD screw
manuals search engine
4 Replacement Procedures
×4
×2
[CONFIDENTIAL] 4-61