Hdd Troubleshooting - Toshiba TECRA A8 series Maintenance Manual

2 Troubleshooting Procedures
2
2.6

HDD Troubleshooting

This section describes how to determine if the HDD is functioning properly. Perform the
steps below starting with Procedure 1 and continuing with the other procedures as required.
CAUTION: The contents of the hard disk will be erased when you execute the HDD
Procedure 1
Insert the Toshiba DOS system disk and restart the computer with U key holding down.
Perform the following checks:
Check 1
Check 2
Check 3
Check 4
2-48
Downloaded from www.Manualslib.com
Procedure 1: Partition Check
Procedure 2: Message Check
Procedure 3: Format Check
Procedure 4: Diagnostic Test Program Execution Check
Procedure 5: Connector Check and Replacement Check
troubleshooting procedures. Transfer the contents of the hard disk to floppy
disks or other storage media.
Partition Check
Type C: and press Enter. If you cannot change to drive C, go to Check 2. If you
can change to drive C, go to Procedure 2.
Type FDISK and press Enter. Choose Display Partition Information from the
FDISK menu. If drive C is listed, go to Check 3. If drive C is not listed, return to
the FDISK menu and choose the option to create a DOS partition on drive C.
Restart the computer from the Toshiba DOS system disk. If the problem still
exists, go to Procedure 2.
If drive C is listed as active in the FDISK menu, go to Check 4. If drive C is not
listed as active, return to the FDISK menu and choose the option to set the active
partition for drive C. Restart the computer and then go to Procedure 2.
Remove the FD and restart the computer. If the problem still exists, go to
Procedure 2.
[CONFIDENTIAL]
manuals search engine
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)

2.6 HDD Troubleshooting