TOHATSU MD 40B2 Owner's Manual page 47

1
2
3
4
5
1. Air vent screw
2. Link rod
3. From oil filter
4. Vinyl pipe
5. Open side
6. Control lever
ENOM00658-0
75, 90, 115 type (Electric oil pump)
Check to see by eyes if the oil line from the
oil tank to the cylinder block ((1) to (4) in
the 75, 90, 115 model) gets air inside or
not. If there is air inside the oil line, remove
it as follows.
Oil tank-Filter (1)
a. Fill the oil tank up with the specified oil.
b. Remove the pipe of the filter inlet side at
the part (A).
c. Since the oil drains out with air, wait until
air is completely discharged from the
pipe. After checking for no air in the oil
line, reconnect the pipe as it was and
attach the clip to secure pipe connec-
tion.
Filter-Oil Pump-Cylinder Block
[75, 90, 115: (2)–(4)]
a. Turn on the key switch.
b. Within 1 second after the buzzer stops
sounding, remove the stop switch lock.
c. Within 2 seconds after removing the
d. The buzzer sounds 3 times and the oil
e. When air is completely removed from
6
75, 90, 115
ENOF00652-0
1. Look
2. Key switch
3. Stop switch knob
1. Oil tank-Filter
2. Filter-Oil Pump
3. 75,90:Oil Pump-Cylinder Block (seven lines)
4. 115:Oil Pump-Cylinder Block (nine lines)
ENGINE OPERATION
stop switch lock, quickly repeat pulling
and pushing back the stop switch knob
2 times.
pump is actuated for about 1 minute for
pressure feed or oil.
the oil line, turn off the key switch.
ON
OFF
1
A
3, 4
47
START
2
3
ENOF00653-0
2
1
ENOF00654-0
7