Configuring Cdp; Displaying Statistics; Displaying Gigabit Ethernet Interface Statistics - Cisco MDS 9000 series Configuration Manual

Chapter 6 Configuring IP Storage
S e n d d o c u m e n t a t i o n c o m m e n t s t o f m - d o c f e e d b a c k @ c i s c o . c o m
Command
Step 6
switch(config-if)# channel-group 10
gigabitethernet 9/3 added to port-channel 10
and disabled
please do the same operation on the switch at
the other end of the port-channel, then do "no
shutdown" at both ends to bring them up
switch(config-if)#
Step 7
switch(config-if)# no shutdown
Step 8
switch(config)# interface gigabitethernet 9/4
switch(config-if)#
Step 9
switch(config-if)# channel-group 10
gigabitethernet 9/4 added to port-channel 10
and disabled
please do the same operation on the switch at
the other end of the port-channel, then do "no
shutdown" at both ends to bring them up
Step 10
switch(config-if)# no shutdown
Gigabit Ethernet interfaces cannot be added to a PortChannel if one of the following cases apply:
Note
- The interface already has an IP address assigned.
- The subinterfaces are configured on that interface.
- The interface already has an associated IPv4-ACL rule and the PortChannel does not.

Configuring CDP

The Cisco Discovery Protocol (CDP) is supported on the management Ethernet interface on the
supervisor module and the Gigabit Ethernet interfaces on the IPS module or MPS-14/2 module.
See the Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide.

Displaying Statistics

This section provides examples to verify Gigabit Ethernet and TCP/IP statistics on the IP storage ports.

Displaying Gigabit Ethernet Interface Statistics

Use the show interface gigabitethernet command on each switch to verify that the interfaces are up and
functioning as desired. See
Example 6-1
switch# show interface gigabitethernet 8/1
GigabitEthernet8/1 is up
OL-19524-01,Cisco MDS NX-OS Release 4.2(1)
Example 6-1
Displays the Gigabit Ethernet Interface
Hardware is GigabitEthernet, address is 0005.3000.a98e
Internet address is 10.1.3.1/24
MTU 1500 bytes, BW 1000000 Kbit
Port mode is IPS
Purpose
Adds Gigabit Ethernet interfaces 9/3 to channel
group 10. If channel group 10 does not exist, it
is created. The port is shut down.
Enables the selected interface.
Configures the specified Gigabit Ethernet
interface (slot 9, port 4).
Adds Gigabit Ethernet interfaces 9/4 to channel
group 10. The port is shut down.
Enables the selected interface.
and Example 6-2.
<-----------The interface is in the up state.
Cisco Fabric Manager IP Services Configuration Guide
Configuring CDP
6-9