Displaying Ipv4 Vrrp Information - Cisco MDS 9000 series Configuration Manual

Chapter 5 Configuring IP Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 5
switch(config-if-vrrp-ipv6)# track
interface mgmt 0 priority 2
switch(config-if-vrrp-ipv6)# no track

Displaying IPv4 VRRP Information

Use the show vrrp vr command to display configured IPv4 VRRP information (see Examples
5-4).
Example 5-2
switch# show vrrp vr 7 interface vsan 2 configuration
vr id 7 configuration
admin state down
priority 100
no authentication
advertisement-Interval 1
preempt yes
tracking interface vsan1 priority 2
protocol IP
Example 5-3
switch# show vrrp vr 7 interface vsan 2 status
vr id 7 status
MAC address 00:00:5e:00:01:07
Operational state: init
Example 5-4
switch# show vrrp vr 7 interface vsan 2 statistics
vr id 7 statistics
Become master 0
Advertisement 0
Advertisement Interval Error 0
Authentication Failure 0
TTL Error 0
Priority 0 Received 0
Priority 0 Sent 0
Invalid Type 0
Mismatch Address List 0
Invalid Authentication Type 0
Mismatch Authentication 0
Invalid Packet Length 0
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Displays IPv4 VRRP Configured Information
Displays IPv4 VRRP Status Information
Displays IPv4 VRRP Statistics
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
Virtual Router Redundancy Protocol
Purpose
Specifies the priority of the virtual router to be
modified based on the state of the management
interface.
You must enable IPv6 on the tracked interface
Note
for the priority tracking to take affect (see the
"Configuring Basic Connectivity for IPv6"
section on page 8-18). If IPv6 is not enabled,
the interface state is treated as down by VRRP
over IPv6, regardless of the actual state of the
interface.
Disables the tracking feature.
5-2 to
5-25