Basic Operation; Power On / Off; Opening The Monitor; Closing The Monitor - Camos CNT-701 Owner's Manual

POWER ON / OFF

1. POWER ON
Press any button on the unit or Power Button of the remote control to turn the
power on. The monitor is automatically opened. When REVERSE wire is connected
to the signal output (12V) of the reverse gear, the monitor is automatically opened
and the mode is set to RVC
2. POWER OFF
Press the Power Button on the unit more than 1 second or the remote controller again
to turn the power off. And the monitor is automatically closed. If the car key is pulled
out, the monitor will be closed automatically.

OPENING THE MONITOR

Press any button, the monitor will be opened.

CLOSING THE MONITOR

Press Open/Close Button on the unit. The monitor will be closed or opened. If it is
not closed, hold left and right upper side of the monitor and make the monitor parallel
with the unit as the picture.
If the monitor is not paralled to the front of the unit, the monitor
will not be closed.

ADJUSTING TILT POSITION

The tilt position can be adjusted in 8 steps by pressing Tilt Up/Down Button. Each
time you press Tilt Up/Down Button the monitor will swing one step backward or
forward.
110°
60°

Basic Operation

9