Adjusting Move Positon; Adjusting Left/Right Viewing Position; Selecting Mode - Camos CNT-701 Owner's Manual

Basic Operation
ADJUSTING MOVE POSITION
The move position can be adjusted in 4 steps by pressing more than 2 sec Tilt Up /
Down Button or Tilt In / Out Button of the remote controller.
If the monitor is not parallel to the front of the unit, the MOVE
function is not operated. You can hear fast beep tone, when you
operate the mechanism under abnormal conditions (Minimum,
Maximum, crooked angle of the front panel).
ADJUSTING LEFT / RIGHT VIEWING POSITION
The monitor's left / right position can be adjusted for easier viewing by hand as the
picture below.

SELECTING MODE

Press Mode Button to select the desired mode. Each time you press this button, the
mode changes as follows.
AV1 AV2
If the REVERSE wire is connected to power output of the
reverse gear, the mode will be automatically changed to RVC
when the gear is positioned to REVERSE.
10
7mm 7mm
RVC